Clutch setting

gosmart

Hi all!

Need some advice on clutch settings.

Clutch is disengaged only when fully pressed. Minor release of pedal engages it completely so it is very difficult to control.

Can I move this point to e.g. half pedal pressed?
 
Try setting your clutch axis sensitivity as low as it will go in the control settings (check which axis it is in the controls list, then look for that in the Controller 1 tab)

If you want to go further and create a deadzone, you should be able to do it with DxTweak2 from www.wingmanteam.com (aimed mainly at logitech, but I think it will work with any input device).
 
Actually, do just the opposite.. remember the clutch pedal is backwards. You lift it off the floor not press it to the floor. Set the clutch axis to %100 and you will have to lift a lot farther before the clutch fully locks.
 
Sorry, yep, been a while since I made that adjustment :)

Mine's on 100%
 
You must log in or register to reply here.

Back
Top